Section 3 (Transfer (4WD) System)
WARNING: This page is about a different variant/trim than selected.
- Precautions
- General Description
- 4WD System: System Description
- 4WD System: CAN Communication
- Cross-Sectional View
- 4WD System: Power Transfer
- Schematic and Routing Diagram
- Component Location
- Diagnostic Information and Procedures
- Diagnosis and Repair Workflow
- SDT Function (4WD)
- NVH Troubleshooting Chart
- Transfer Control Unit: Reference Value
- DTC Index: Transfer Control Unit
- DTC Index
- DTC P1801 & DTC P1811: Power Supply Circuit for Transfer Control Unit
- DTC P1802, DTC P1803, DTC P1804 & DTC P1809: Transfer Control Unit
- DTC P1807: Vehicle Speed Sensor (A/T)
- DTC P1808: Vehicle Speed Sensor (ABS)
- DTC P1810: 4 LO Switch
- DTC P1813: 4WD Shift Switch
- DTC P1814: Wait Detection Switch
- DTC P1816: PNP Switch (A/T)
- DTC P1816: PNP Switch (M/T)
- DTC P1817: Actuator Motor
- DTC P1818: Actuator Position Switch
- DTC P1819: Transfer Control Device
- DTC P1820: Engine Speed Signal
- DTC U1010: Control Unit (CAN)
- ATP Switch Circuit Check
- 4WD System Symptoms: Symptom Table
- 4WD Warning Lamp Does Not Turn On
- 4WD Shift Indicator Lamp and 4Lo Indicator Lamp Do Not Turn On
- 4WD Shift Indicator Lamp or 4Lo Indicator Lamp Do Not Change
- ATP Warning Lamp Does Not Turn On
- 4WD Shift Indicator Lamp Keeps Flashing
- 4WD Warning Lamp Flashes Slowly
- Repair Instructions
- Transfer Fluid: Inspection
- Transfer Fluid: Replacement
- Transfer Control Unit: Removal and Installation
- Front Oil Seal: Removal and Installation
- Rear Oil Seal: Removal and Installation
- Transfer Control Device: Removal and Installation
- Air Breather Hose: Removal and Installation
- Transfer Assembly: Exploded View
- Transfer Assembly: Removal and Installation
- Transfer Assembly: Disassembly and Assembly
- Planetary Carrier: Disassembly and Assembly
- Front Drive Shaft: Disassembly and Assembly
- Shift Control: Disassembly and Assembly
- Specifications
- Special Tools and Equipment