LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer (4WD) System) >> Repair Instructions >> Transfer Control Unit: Removal and Installation >> Removal

Transfer Control Unit: Removal and Installation: Removal

WARNING: This page is about a different variant/trim than selected.
  1. Switch 4WD shift switch to 2WD and set transfer assembly to 2WD.
    CAUTION: When removing transfer control unit, transfer state must be at 2WD.
  2. Turn the ignition switch OFF and disconnect negative battery terminal.
  3. Remove the lower instrument panel LH. Refer to [INSTRUMENT LOWER PANEL LH: REMOVAL AND INSTALLATION ]
  4. Disconnect the two transfer control unit connectors.
    Fig 1: Identifying Transfer Control Unit Connectors
    G06444836Courtesy of SUZUKI OF AMERICA CORP.
  5. Remove the transfer control unit bolts.
  6. Remove the transfer control unit.
scientia non olet · About LEMON Manuals