Component Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Disconnect 4LO switch harness connector.
- Remove 4LO switch. Refer to [4WD SYSTEM: COMPONENT PARTS LOCATION ].
- Push and release 4LO switch and check continuity between 4LO switch terminals 12 and 13.
Courtesy of SUZUKI OF AMERICA CORP.
TERMINAL CONTINUITY CHARTTerminal Condition Continuity 12 - 13 Push 4LO switch Yes Release 4LO switch No - If the inspection results are not normal replace the 4LO switch.