LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer (4WD) System) >> Diagnostic Information and Procedures >> ATP Switch Circuit Check >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch "OFF". (Stay for at least 5 seconds.)
  2. Disconnect ATP switch harness connector.
  3. Remove ATP switch. Refer to [4WD SYSTEM: COMPONENT PARTS LOCATION ].
  4. Push and release ATP switch and check continuity between ATP switch terminals 8 and 9.
    Fig 1: Checking Continuity Between ATP Switch Terminals 8 And 9
    G06444820Courtesy of SUZUKI OF AMERICA CORP.
    TERMINAL CONTINUITY CHART

    Terminal Condition Continuity
    8 - 9 Push ATP switch Yes
    Release ATP switch No
  5. If the inspection results are abnormal replace the ATP switch.
scientia non olet · About LEMON Manuals