LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2012 >> Equator Base >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Transfer (4WD) System) >> Diagnostic Information and Procedures >> DTC P1816: PNP Switch (M/T) >> Component Inspection

Component Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch "OFF". (Stay for at least 5 seconds.)
  2. Disconnect neutral position switch harness connector.
  3. Remove neutral position switch. Refer to [4WD SYSTEM: COMPONENT PARTS LOCATION ].
  4. Push and release neutral position switch and check continuity between neutral position switch terminals 1 and 2.
    Fig 1: Checking Continuity Between Neutral Position Switch Terminals 1 And 2
    G06444777Courtesy of SUZUKI OF AMERICA CORP.
    TERMINAL CONTINUITY CHART

    Terminal Condition Continuity
    1 - 2 Push neutral position switch Yes
    Release neutral position switch No
  5. If NG, replace the neutral position switch.
scientia non olet · About LEMON Manuals