Component Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Disconnect wait detection switch harness connector.
- Remove wait detection switch. Refer to [4WD SYSTEM: COMPONENT PARTS LOCATION ].
- Push and release wait detection switch and check continuity between wait detection switch terminals 10 and 11.
Courtesy of SUZUKI OF AMERICA CORP.
TERMINAL CONTINUITY CHARTTerminal Condition Continuity 10 - 11 Push wait detection switch Yes Release wait detection switch No - If the inspection results are abnormal replace the wait detection switch.