Component Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch "OFF". (Stay for at least 5 seconds.)
- Remove 4WD shift switch harness connector.
- Operate 4WD shift switch and check continuity between 4WD shift switch terminals.TERMINAL CONTINUITY CHART
Terminal Condition Continuity 1 - 3 4WD shift switch: 2WD Yes 4WD shift switch: 4H and 4LO No 1 - 5 4WD shift switch: 4H Yes 4WD shift switch: 2WD and 4LO No 1 - 6 4WD shift switch: 4LO Yes 4WD shift switch: 2WD and 4H No - If the inspection results are abnormal replace the 4WD shift switch.