Section 34 (Automatic Air Conditioning)
WARNING: This page is about a different car, the 2005 Mitsubishi Montero. However, it is still accessible from the selected car via links, so may be relevant.
- General Description
- Auto A/C Diagnosis
- Introduction
- Automatic Air Conditioning Troubleshooting Strategy
- Diagnostic Function
- Diagnostic Trouble Code Chart
- Symptom Chart
- Diagnostic Trouble Code Procedures
- DTC 11, 12: Inside Air Temperature Sensor System
- DTC 13, 14: Ambient Air Temperature Sensor System
- DTC 15, 16: Heater Water Temperature Sensor System
- DTC 21, 22: A/C sensor System
- DTC 31: Potentiometer System of Air Mixing Damper Control Motor Assembly
- DTC 32: Potentiometer System of Air Outlet Changeover Damper Control Motor Assembly.
- Symptom Procedures
- INSPECTION PROCEDURE 1: Communication with scan tool is not Possible.
- INSPECTION PROCEDURE 2: Air Conditioning does not Operate.
- INSPECTION PROCEDURE 3: A/C Outlet Air Temperature cannot be Set.
- INSPECTION PROCEDURE 4: Blower does not Operate.
- INSPECTION PROCEDURE 5: Blower Air Amount cannot be Changed.
- INSPECTION PROCEDURE 6: Air Outlet Vent cannot be Changed.
- INSPECTION PROCEDURE 7: Inside/Outside Air Changeover is not Possible.
- INSPECTION PROCEDURE 8: Rear Defogger does not Operate.
- INSPECTION PROCEDURE 9: Condenser Fan does not Operate.
- INSPECTION PROCEDURE 10: Malfunction of the A/C-ECU Power Supply System.
- INSPECTION PROCEDURE 11: The A/C Indicator Flashes.
- Data List Reference Table
- Actuator Test Reference
- Check At Ecu Terminal
- Special Tools
- On-Vehicle Service
- A/C Control Panel And A/C Control Unit
- Heater Unit
- Heater Blower Controller Unit
- Damper Control Motor Assembly
- Sensors
- Rear A/C Switch And Front Rear Fan Switch
- Rear A/C Control Unit
- Rear Heater Unit And Rear Blower Assembly
- Photo Sensor
- Ambient Temperature Sensor
- Refrigerant Line
- Other Parts
- Specifications