Section 5 (Rear Axle - AWD)
WARNING: This page is about a different variant/trim than selected.
- General Information
- General Specifications
- Service Specifications
- Lubricants
- Sealant And Adhesive
- Component Identification
- Rear Axle Diagnosis
- Introduction
- Troubleshooting Strategy
- Symptom Chart
- Symptom Procedures
- INSPECTION PROCEDURE 1: Noise during Wheel Rotation (DRIVESHAFT)
- INSPECTION PROCEDURE 2: Constant Noise (DIFFERENTIAL)
- INSPECTION PROCEDURE 3: Gear Noise while Driving (DIFFERENTIAL)
- INSPECTION PROCEDURE 4: Gear Noise while Coasting (DIFFERENTIAL)
- INSPECTION PROCEDURE 5: Bearing Noise while Driving or Coasting (DIFFERENTIAL)
- INSPECTION PROCEDURE 6: Noise while Turning (DIFFERENTIAL)
- INSPECTION PROCEDURE 7: Heat (DIFFERENTIAL)
- INSPECTION PROCEDURE 8: Differential gear oil Leakage (DIFFERENTIAL)
- Special Tools
- On-Vehicle Service
- Rear Axle Hub Assembly
- Driveshaft Assembly
- Differential Carrier Assembly
- Removal And Installation
- Disassembly
- Notes
- Disassembly Service Point
- Drive Gear Backlash
- Drive Gear RUNOUT On Backside
- Differential Gear Backlash
- Final Drive Gear Teeth Contact Adjustment
- Notes
- Differential Case Assembly/Differential Side Bearing Spacer/Differential Side Bearing Outer Race Removal
- Differential Side Bearing Inner Race Removal
- Drive Gear Removal
- Lock Pin Driving Out
- Differential Nut Removal
- Drive Pinion Rear Bearing Inner Race Removal
- Drive Pinion Front Bearing Outer Race Removal
- Drive Pinion Rear Bearing Outer Race Removal
- Assembly
- Notes
- Lubricant/Sealant Application Points
- Assembly Service Point
- Drive Pinion Rear Bearing Outer Race Press-Fitting
- Drive Pinion Front Bearing Outer Race Press-Fitting
- Drive Pinion Height Adjustment
- Drive Pinion Rotation Torque Adjustment/Oil Seal Press-Fitting
- Differential Gear Backlash Adjustment
- Lock Pin Installation
- Drive Gear Installation
- Differential Side Bearing Inner Race Installation
- Final Drive Gear Backlash Adjustment
- Oil Seal Press-Fitting