General Specifications
WARNING: This page is about a different variant/trim than selected.
| Item | Specification | ||||
|---|---|---|---|---|---|
| Rear axle | |||||
| Wheel bearing | Type | Unit ball bearing (double-row angular contact ball bearing) | |||
| Driveshaft Joint | Type | Outer | Outboard joint |
||
| Inner | Inboard joint |
||||
| Shaft length(1) x Shaft diameter mm (in) | LH | 496.0 X 23 (19.53 X 0.91) | |||
| RH | 576.4 X 23 (22.69 X 0.91) | ||||
| Differential | |||||
| Reduction gear type | Hypoid gear | ||||
| Reduction ratio | 2.352 | ||||
| Differential gear type (Type X number of gears) | Side gear | Straight bevel gear X 2 | |||
| Pinion gear | Straight bevel gear X 2 | ||||
| Number of teeth | Drive gear | 40 | |||
| Drive pinion | 17 | ||||
| Side gear | 14 | ||||
| Pinion gear | 10 | ||||
| Bearings (Outside diameter X Inside diameter) mm (in) | Side | 72 X 35 (2.83 X 1.38) | |||
| Front | 55 X 30 (2.17 X 1.18) | ||||
| Rear | 68 X 40 (2.68 X 1.57) | ||||
|
NOTE:
|
|||||