Tightening Torque Specifications
CAUTION:
For fastener with * (asterisk) below, be sure to tighten it according to specified procedure in "Repair Instructions".
TORQUE SPECIFICATION
| Fastening part | Tightening torque | ||
|---|---|---|---|
| N.m | kgf-m | lbf-ft | |
| Tie-rod end nut | 35 | 3.6 | 26.0 |
| Tie-rod end lock nut | 65 | 6.6 | 48.0 |
| Steering lower shaft bolt | 25 | 2.5 | 18.5 |
| Gear case high pressure pipe union bolt | 35 | 3.6 | 26.0 |
| Gear case cylinder pipe flare nut | 25 | 2.5 | 18.5 |
| Gear case mounting bolt | 105 | 10.7 | 77.5 |
| Gear case low pressure pipe flare nut | 35 | 3.6 | 26.0 |
| Stabilizer bar mount bracket mount bolt | 60 | 6.1 | 44.5 |
| Tie-rod ball nut | 90 | 9.2 | 66.5 |
| P/S pump mounting bolt | 25 | 2.5 | 18.5 |
| P/S pump high pressure pipe union bolt | 60 | 6.1 | 44.5 |
| P/S pump cover bolt | 28 | 2.9 | 21.0 |
| Pressure switch | 28 | 2.9 | 21.0 |
| Plug | 59 | 6.0 | 43.5 |
| Suction connector bolt | 12 | 1.2 | 9.0 |
NOTE:
The specified tightening torque is also described in the following.
P/S GEAR CASE ASSEMBLY COMPONENTS
P/S HOSE/PIPE COMPONENTS
P/S PUMP COMPONENTS
P/S GEAR CASE ASSEMBLY COMPONENTS
P/S HOSE/PIPE COMPONENTS
P/S PUMP COMPONENTS
Reference:
For the tightening torque of fastener not specified in this section, refer to FASTENER INFORMATION .