LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2013 >> Outback Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 9 (Continuously Variable Transaxle (CVT)) >> Converter Case >> Installation

Converter Case: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Install the oil pump. Refer to INSTALLATION .
  2. Install the oil pump chain cover. Refer to INSTALLATION .
  3. Install the front differential assembly. Refer to INSTALLATION .
  4. Install the drive pinion shaft assembly. Refer to INSTALLATION .
  5. Install the forward clutch assembly. Refer to INSTALLATION .
  6. Install the reverse brake assembly. Refer to INSTALLATION .
  7. Install the primary pulley, secondary pulley and variator chain. Refer to INSTALLATION .
  8. Install the reduction drive gear. Refer to INSTALLATION .
  9. Install the transmission case. Refer to INSTALLATION .
  10. Install the transmission control device. Refer to INSTALLATION .
  11. Install the oil strainer and oil pan. Refer to INSTALLATION .
  12. Install the reduction driven gear assembly. Refer to INSTALLATION .
  13. Install the transfer driven gear assembly. Refer to INSTALLATION .
  14. Install the transfer clutch assembly. Refer to INSTALLATION .
  15. Install the parking pawl. Refer to INSTALLATION .
  16. Install the extension case. Refer to INSTALLATION .
  17. Install the inhibitor switch. Refer to INSTALLATION .
  18. Install the secondary speed sensor. Refer to INSTALLATION .
  19. Install the primary speed sensor. Refer to INSTALLATION .
  20. Install the turbine speed sensor. Refer to INSTALLATION .
  21. Install the transmission harness. Refer to INSTALLATION .
  22. Install the control valve body. Refer to INSTALLATION .
  23. Install the air breather hose. Refer to INSTALLATION .
  24. Install the transmission assembly to the vehicle. Refer to INSTALLATION .
scientia non olet · About LEMON Manuals