Diagnostic Mode 6 - Check Test Results of Components Not Continuously Monitored: Notes

WARNING: This page is about a different variant/trim than selected.

The individual tests in Diagnostic Mode 05 display the results of emission related components and systems which are not continuously monitored.

The min max values for each individual test in Mode 05 represent the min max operating values for a properly operating system. This data is provided to the individual aftermarket scan tool companies for development of their scan tool. Depending on the scan tool being used, the min max values shown may vary, or be rounded up or down to the nearest decimal point depending on the aftermarket scan tool company's development process. e.g.:

	Minimum Value
GST article documentation	0.3499
Aftermarket Scan Tool display	0.35

Depending on the scan tool and protocol used, the information displayed in Diagnostic Mode 06 may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), On-Board Diagnostic Monitor Identifier (OBDMID), or contain no name at all and may be referenced by only a number.

Test requirements

Exhaust system must be properly sealed between the catalytic converter and the cylinder heads.
No DTCs stored in the DTC memory.
Coolant temperature at least 80° C.

Work procedure

Connect the scan tool.
Start the engine and run at idle.

NOTE:

If the engine does not start, crank the engine using starter for at least 5 seconds, do not switch the ignition off afterward under any circumstances.

Select "Diagnostic Mode 05 - Check Lambda Test Results.".
Select the desired "Test-ID" of the component or system that is to be monitored, e.g. "Test-ID 01: Oxygen Sensor Monitor Bank 1 - Sensor 1".
Select the desired "Test-ID".

The current minimum and maximum values will be displayed on the scan tool screen.

The following table is a numerical list of all "Test-IDs" or "Hex-IDs" that may be selected.

OBDMID (Hex-ID)	Component or System
01 ($01): OBDMID 01 ($01): Oxygen Sensor Monitor Bank 1 - Sensor 1	Oxygen Sensor Monitor Bank 1 - Sensor 1
02 ($02): OBDMID 02 ($02): Oxygen Sensor Monitor Bank 1- Sensor 2	Oxygen Sensor Monitor Bank 1 - Sensor 2
05 ($05): OBDMID 05 ($05): Oxygen Sensor Monitor Bank 2 - Sensor 1	Oxygen Sensor Monitor Bank 2 - Sensor 1
06 ($06): OBDMID 06 ($06): Oxygen Sensor Monitor Bank 2 - Sensor 2	Oxygen Sensor Monitor Bank 2 - Sensor 2
09 ($09): OBDMID 09 ($09): Oxygen Sensor Monitor Bank 3 - Sensor 1	Oxygen Sensor Monitor Bank 3 - Sensor 1
10 ($0A): OBDMID 10 ($0A): Oxygen Sensor Monitor Bank 3- Sensor 2	Oxygen Sensor Monitor Bank 3- Sensor 2
13 ($0D): OBDMID 13 ($0D): Oxygen Sensor Monitor Bank 4 - Sensor 1	Oxygen Sensor Monitor Bank 4 - Sensor 1
14 ($0E): OBDMID 14 ($0E): Oxygen Sensor Monitor Bank 4 - Sensor 2	Oxygen Sensor Monitor Bank 4 - Sensor 2
33 ($21): OBDMID 33 ($21): Catalyst Monitor Bank 1	Catalyst Monitor Bank 1
34 ($22): OBDMID 34 ($22): Catalyst Monitor Bank 2	Catalyst Monitor Bank 2
36 ($24): OBDMID 36 ($24): Catalyst Monitor Bank 2	Catalyst Monitor Bank 2
59 (3B): OBDMID 59 (3B): EVAP Monitor (0.040)	EVAP Monitor (0.40)
60 (3C): OBDMID 60 (3C): EVAP Monitor (0.020)	EVAP Monitor (0.20)
61 (3D): OBDMID 61 (3D): Tank Vent Valve function check	Purge Flow Monitor
65 ($41): OBDMID 65 ($41): Oxygen Sensor Heater Monitor Bank 1 - Sensor 1	Oxygen Sensor Heater Monitor Bank 1 - Sensor 1
66 ($42): OBDMID 66 ($42): Oxygen Sensor Heater Monitor Bank 1 - Sensor 2	Oxygen Sensor Heater Monitor Bank 1 - Sensor 2
69 ($45): OBDMID 69 ($45): Oxygen Sensor Heater Monitor Bank 2- Sensor 1	Oxygen Sensor Heater Monitor Bank 2 - Sensor 1
70 ($46): OBDMID 70 ($46): Oxygen Sensor Heater Monitor Bank 2 - Sensor 2	Oxygen Sensor Heater Monitor Bank 2 - Sensor 2
73 ($49): OBDMID 73 ($49): Oxygen Sensor Heater Monitor Bank 3 - Sensor 1	Oxygen Sensor Heater Monitor Bank 3 - Sensor 1
74 ($4A): OBDMID 74 ($4A): Oxygen Sensor Heater Monitor Bank 3 - Sensor 2	Oxygen Sensor Heater Monitor Bank 1 - Sensor 2
77 ($4D): OBDMID 77 ($4D): Oxygen Sensor Heater Monitor Bank 4- Sensor 1	Oxygen Sensor Heater Monitor Bank 4- Sensor 1
78 ($4E): OBDMID 77 ($4D): Oxygen Sensor Heater Monitor Bank 4- Sensor 1	Oxygen Sensor Heater Monitor Bank 4 - Sensor 2
113 ($71): OBDMID $71 (113): Secondary Air Injection (AIR) System 1 (Bank 1)	Secondary Air Injection (AIR) System Bank 1
114 ($72): OBDMID $72 (114): Secondary Air Injection (AIR) System 2 (Bank 2)	Secondary Air Injection (AIR) System Bank 2
162 ($A2): OBDMID 162 ($A2): Mis-Fire Cylinder 1 Data	Mis-Fire Cylinder 1 Data
163 ($A3): OBDMID 163 ($A3): Mis-Fire Cylinder 2 Data	Mis-Fire Cylinder 2 Data
164 ($A4): OBDMID 164 ($A4): Mis-Fire Cylinder 3 Data	Mis-Fire Cylinder 3 Data
165 ($A5): OBDMID 165 ($A5): Mis-Fire Cylinder 4 Data	Mis-Fire Cylinder 4 Data
166 ($A6): OBDMID 166 ($A6): Mis-Fire Cylinder 5 Data	Mis-Fire Cylinder 5 Data
167 ($A7): OBDMID 167 ($A7): Mis-Fire Cylinder 6 Data	Mis-Fire Cylinder 6 Data
168 ($A8): OBDMID 168 ($A8): Mis-Fire Cylinder 7 Data	Mis-Fire Cylinder 7 Data
169 ($A9): Test-ID 169 ($A9): Mis-Fire Cylinder 8 Data	Mis-Fire Cylinder 8 Data