OBDMID 60 (3C): EVAP Monitor (0.020)
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "OBDMID 60 ($3C)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 129 ($81) | P0456 | Fuel Tank Leak Test. Pin hole Leak. | 65535 | Refer to DTC P0456 under Control module and output signals . |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.