OBDMID 59 (3B): EVAP Monitor (0.040)
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "OBDMID 59 ($3B)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 129 ($81) | P0442 | Fuel Tank Leak Test. Small Leak. | 65535 | Refer to DTC P0442 under Control module and output signals . | |
| 130 ($82) | P2403 | Leak detection pump check: Close reed contact after initial/continuation flushing (tank vent phase). | 0 | 1.0 sec. | Refer to DTC P2403 under Control module and output signals . |
| 131 ($83) | P2404 | Leak detection pump check: Reed contact open. | 0 | 25 counts | Refer to DTC P2404 under Control module and output signals . |
| 132 ($84) | P2403 | Leak detection pump check: Reed contact open. | 6.4g | 65535 | Refer to DTC P2403 under Control module and output signals . |
| 133 ($85) | Leak detection pump check: EVAP canister shut-off valve. | 0 |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.