Test-ID 169 ($A9): Mis-Fire Cylinder 8 Data
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 169 ($A9)".
- Select the desired "Test-ID (TID)" or "Hex-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min./Max. Values | Additional Information | |
|---|---|---|---|---|---|
| 11 ($0B) | P0308 | Crankshaft speed fluctuation, single or multiple misfire check. | 0 - 65535 (counts) | Refer to DTC P0308 under Control module and output signals . | |
| 12 ($0C) | P0308 | Crankshaft speed fluctuation, single or multiple misfire check. | 0 - 65535 (counts) | Refer to DTC P0308 under Control module and output signals . | |
- If any of the components or systems fail to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
- End of diagnosis.