Drive Pinion Shaft Assembly: Removal
- Remove the transmission assembly from vehicle body. Refer to
REMOVAL , Automatic Transmission Assembly.
- Pull out the torque converter clutch assembly. Refer to
REMOVAL , Torque Converter Clutch Assembly.
- Remove the input shaft.
Courtesy of SUBARU OF AMERICA, INC.
- Lift up the lever on the rear side of transmission harness connector, and then disconnect it from the stay.
- Disconnect the inhibitor switch connector from the stay.
- Disconnect the air breather hose. Refer to
REMOVAL , Air Breather Hose.
- Remove the oil charge pipe. Refer to
REMOVAL , Oil Charge Pipe.
- Remove the ATF inlet and outlet pipes. Refer to
REMOVAL , ATF Cooler Pipe and Hose.
- Separate the converter case and transmission case. Refer to
REMOVAL , Converter Case.
- Separate the transmission case and extension case section. Refer to
REMOVAL , Extension Case.
- Remove the reduction drive gear. Refer to
REMOVAL , Reduction Drive Gear.
- Remove the reduction driven gear. Refer to
REMOVAL , Reduction Driven Gear.
- Remove the drive pinion shaft mounting bolt and remove the drive shaft assembly from oil pump housing.
Courtesy of SUBARU OF AMERICA, INC.