Brake Light Unit Inspection: Notes
- Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
- Remove the following parts:
- Rear package tray (See REAR PACKAGE TRAY REMOVAL/INSTALLATION .)
- Trunk board (See TRUNK BOARD REMOVAL/INSTALLATION .)
- Trunk covering (See TRUNK COVERING REMOVAL/INSTALLATION .)
- Bass-box (with Bose®) (See BASS-BOX REMOVAL/INSTALLATION .)
- Trunk box (See TRUNK BOX REMOVAL/INSTALLATION .)
- Trunk end trim (See TRUNK END TRIM REMOVAL/INSTALLATION .)
- Reconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION .)
- Verify that the voltages of each of the terminals are as indicated in the terminal voltage table.
- If the voltage is not as indicated in the table, inspect the parts under Inspection item(s).
- If the system does not work normally even though the parts or related wiring harnesses do not have any malfunction, replace the brake light unit. (See BRAKE LIGHT UNIT REMOVAL/INSTALLATION .)