LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Exterior/Interior Trim >> Interior Trim >> Foot Support Removal/Installation

Foot Support Removal/Installation

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION ).
  2. Remove the following parts:
    1. Passenger-side scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION ).
    2. Passenger-side front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    3. Passenger-side A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION ).
    4. Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION ).
    5. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION ).
    6. Shift lever knob (MT)
    7. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION ).
    8. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION ).
    9. Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION ).
    10. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION ).
    11. Front console panel (See FRONT CONSOLE PANEL REMOVAL/INSTALLATION ).
    12. Front console component (See FRONT CONSOLE REMOVAL/INSTALLATION ).
    13. Front cup holder bracket (See FRONT CUP HOLDER BRACKET REMOVAL/INSTALLATION ).
  3. Partially peel back the floor covering No. 1.
  4. Remove the fastener.
    Fig 1: Identifying Fasteners And Foot Support
    G11275270Courtesy of MAZDA MOTORS CORP.
  5. Remove the foot support in the direction of arrow shown in the figure.
    Fig 2: Removing Foot Support
    G11275271Courtesy of MAZDA MOTORS CORP.
  6. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals