LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2017 >> MX-5 Miata Club, Automatic Trans >> Repair and Diagnosis >> Body & Frame >> Door Locks >> Security And Locks >> Push Button Start Inspection >> LED Illumination Inspection

LED Illumination Inspection

  1. Disconnect the negative battery cable. (See NEGATIVE BATTERY CABLE DISCONNECTION/CONNECTION ).
  2. Remove the following parts:
    1. Selector lever knob (AT) (See AUTOMATIC TRANSMISSION SHIFT MECHANISM REMOVAL/INSTALLATION ).
    2. Shift lever knob (MT)
    3. Shift panel component (See SHIFT PANEL REMOVAL/INSTALLATION ).
    4. Upper panel (See UPPER PANEL REMOVAL/INSTALLATION ).
    5. Parking brake lever boot panel (See PARKING BRAKE LEVER BOOT PANEL REMOVAL/INSTALLATION ).
    6. Rear console (See REAR CONSOLE REMOVAL/INSTALLATION ).
    7. Front console panel (See FRONT CONSOLE PANEL REMOVAL/INSTALLATION ).
    8. Front console component (See FRONT CONSOLE REMOVAL/INSTALLATION ).
    9. Scuff plate (See SCUFF PLATE REMOVAL/INSTALLATION ).
    10. Front side trim (See FRONT SIDE TRIM REMOVAL/INSTALLATION ).
    11. A-pillar trim (See A-PILLAR TRIM REMOVAL/INSTALLATION ).
    12. Hood release lever (See HOOD RELEASE LEVER AND RELEASE CABLE REMOVAL/INSTALLATION ).
    13. Driver -side lower panel (See DRIVER-SIDE LOWER PANEL REMOVAL/INSTALLATION ).
    14. Passenger-side lower panel (See PASSENGER-SIDE LOWER PANEL REMOVAL/INSTALLATION ).
    15. Center panel No. 1 (See CENTER PANEL NO. 1 REMOVAL/INSTALLATION ).
    16. Push button start. (See PUSH BUTTON START REMOVAL/INSTALLATION ).
  3. Apply battery positive voltage and connect the ground to the push button start terminals and verify that the LED illuminates as indicated in the table.
Fig 1: Applying Battery Positive Voltage Into Push Button Start Terminals
G11273557Courtesy of MAZDA MOTORS CORP.
Fig 2: Identifying Push Button Start Illumination Positions
G11273558Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals