LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> B2300 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Interior Trim) >> Front Floor Covering Removal/Installation

Front Floor Covering Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the front seats. (See FRONT SEAT REMOVAL/INSTALLATION .)
  3. Remove the second-row seats. (See SECOND-ROW SEAT REMOVAL .) (See SECOND-ROW SEAT INSTALLATION .)
  4. Remove the front scuff plate.
  5. Remove the rear scuff plate.
  6. Remove the console lower cover. (See CONSOLE LOWER COVER REMOVAL/INSTALLATION .)
  7. Remove the front side trim. (See FRONT SIDE TRIM REMOVAL/INSTALLATION .)
  8. Remove the B-pillar lower trim. (See B-PILLAR LOWER TRIM REMOVAL/INSTALLATION .)
  9. Remove the lower anchor of the front seat belt installation bolt.
  10. Remove the rear side trim. (See REAR SIDE TRIM REMOVAL/INSTALLATION .)
  11. Remove the long slider cover and adapter cover. (See LONG SLIDER AND ADAPTER REMOVAL/INSTALLATION .)
  12. Remove the parking brake cover.
  13. Remove the rear heat duct (for second-row seat).
  14. Remove the fasteners, and remove the floor covering.
    Fig 1: Removing/Installing Front Floor Covering
    G02564034Courtesy of MAZDA MOTORS CORP.
  15. Remove the floor covering from the vehicle through the passenger-side front door.
  16. Install in the reverse order of removal.
scientia non olet · About LEMON Manuals