LEMON Manuals: Even more car manuals for everyone
Home >> Mazda >> 2005 >> B2300 Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 249 (Interior Trim) >> B-Pillar Lower Trim Removal/Installation

B-Pillar Lower Trim Removal/Installation

WARNING: This page is about a different car, the 2004 Mazda MPV. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
  • Handling the side air bag sensor improperly can accidentally deploy the side air bag module, which may seriously injure you. Read AIR BAG SAFETY PRECAUTIONS before working around the B-pillar areas. See AIR BAG SAFETY PRECAUTIONS .
NOTE:
  • The side air bag sensor is located in the B-pillar.
  1. Remove the assist handle. (See ASSIST HANDLE REMOVAL/INSTALLATION .)
  2. Remove the front scuff plate.
  3. Remove the rear scuff plate.
  4. Remove the power sliding door rear switch (with power sliding door system).
  5. Turn the seaming welt over.
  6. Remove the fastener.
  7. Disengage clips A using a fastener remover, and remove the B-pillar lower trim.
  8. Install in the reverse order of removal.
    Fig 1: Removing/Installing B-Pillar Lower Trim
    G02564018Courtesy of MAZDA MOTORS CORP.
scientia non olet · About LEMON Manuals