LEMON Manuals: Even more car manuals for everyone
Home >> GMC >> 2002 >> Jimmy 2D Utility, Part Time, Automatic >> Repair and Diagnosis >> Engine Performance >> Remove, Overhaul & Install >> Engine Controls - Removal, Overhaul & Installation >> Fuel Systems >> Intake Manifold >> Removal (2.2L)

Removal (2.2L)

  1. Turn ignition off. Disconnect negative battery cable. Remove air cleaner outlet resonator mounting screw. Disconnect air cleaner outlet resonator clamp at throttle body. Remove air cleaner outlet duct from air cleaner outlet resonator.
  2. Disconnect power brake booster vacuum hose at throttle body. Disconnect crankcase vent hose clamp and crankcase vent hose from top of engine. Remove air cleaner outlet resonator. Loosen remaining air intake duct clamps. Remove air intake duct from top of fan shroud. Remove upper fan shroud retaining screws and upper fan shroud.
  3. Disconnect harness connectors from Idle Air Control (IAC) motor, Manifold Absolute Pressure (MAP) sensor, Throttle Position (TP) sensor and Engine Coolant Temperature (ECT) sensor. See Figure.
  4. Disconnect fuel injector harness connector. Remove fuel injector harness and engine wiring harness from bracket on valve cover and position aside. Disconnect vacuum hoses and EVAP purge tube from throttle body.
  5. Remove EVAP canister purge harness retaining bolt. On models equipped with A/T, remove transmission fluid fill tube retaining bolt. On all models, remove engine wiring harness clip-to-intake manifold retaining nuts.
  6. Disconnect fuel hose from the fuel rail. See FUEL LINE DISCONNECT FITTINGS . Disconnect control cables from throttle body.
  7. Reference mark spark plug wires at spark plugs for reassembly reference. Slightly twist all spark plug wires at spark plugs. Remove all spark plug wires at spark plugs by pulling on the wire boot. Remove spark plug wiring harness retainer from thermostat assembly and position wiring harness aside.
  8. Remove right-side fender wheelwell extension. See Figure. Working through wheelwell, remove rear generator brace. See Figure.
  9. Remove 2 engine wiring harness bracket-to-valve cover bolts. See Figure. Loosen engine wiring harness bracket-to-cylinder head bolt. Remove engine wiring harness bracket.
  10. Remove intake manifold bolts. See Figure. Remove intake manifold nuts. Remove fuel rail bracket. Remove intake manifold.
scientia non olet · About LEMON Manuals