LEMON Manuals: Even more car manuals for everyone
Home >> Buick >> 2012 >> Verano >> Repair and Diagnosis >> Steering >> Steering Wheel And Steering Column >> Repair Instructions >> Steering Column Replacement >> Installation Procedure

Installation Procedure

    Fig 1: Steering Column Insulator
    GM2538054Courtesy of GENERAL MOTORS COMPANY
  1. Install the steering column (1) insulator if necessary.
    2. Fig 2: View Of Steering Column
    GM2027643Courtesy of GENERAL MOTORS COMPANY
    NOTE:
    • Start all nuts by hand before finalizing any torques.
    • Do not bend the steering column energy absorbing straps located on the upper steering column mounting bracket during installation.
  2. Install the steering column (1).
    3. Fig 3: Identifying Steering Column Nuts
    GM2027642Courtesy of GENERAL MOTORS COMPANY
    WARNING:

    Refer to Torque-to-Yield Fastener Warning .

    CAUTION:

    Refer to Fastener Caution .

  3. Install the NEW steering column nuts (1) and tighten the steering column nuts a first pass to 22 N.m (16 lb ft).
  4. Tighten the NEW steering column nuts a final pass to an additional 45 degrees.
    5. WARNING:

    In order to ensure the intended function of the steering column in a vehicle during a crash and in order to avoid personal injury to the driver, perform the following:

    • Tighten the steering column lower fasteners before you tighten the steering column upper fasteners. Failure to do this can damage the steering column.
    • Tighten the steering column fasteners to the specified torque. Overtightening the upper steering column fasteners could affect the steering column collapse.
  5. Remove the tie straps.
  6. Connect any electrical connectors as needed.
  7. Install the windshield wiper and wash switch. Refer to Windshield Wiper and Washer Switch Replacement .
  8. If equipped, install the ignition and start switch housing. Refer to Ignition and Start Switch Housing Replacement .
  9. Install the turn signal switch bracket. Refer to Turn Signal Switch Bracket Replacement .
  10. Install the turn signal switch. Refer to Turn Signal Switch Replacement .
  11. Install the steering angle sensor. Refer to Steering Angle Sensor Replacement .
  12. Install the steering wheel inflatable restraint module coil. Refer to Steering Wheel Airbag Coil Replacement .
  13. Install the steering column lower trim cover. Refer to Steering Column Lower Trim Cover Replacement .
  14. Install the steering column upper trim cover. Refer to Steering Column Upper Trim Cover Replacement .
  15. Install the steering wheel. Refer to Steering Wheel Replacement .
  16. Install the inflatable restraint steering wheel module. Refer to Steering Wheel Inflatable Restraint Module Replacement .
  17. Install the intermediate steering shaft. Refer to Intermediate Steering Shaft Replacement .
  18. Install the knee bolster. Refer to Knee Bolster Replacement .
  19. If equipped, install the inflatable restraint instrument panel lower module. Refer to Inflatable Restraint Instrument Panel Lower Module Replacement - Driver Side .
  20. Calibrate the steering angle sensor. Refer to Power Steering Control Module Calibration .
scientia non olet · About LEMON Manuals