Diagnostic Mode 6: Checking Test Results of Components that are not Continuously Monitored: Notes

WARNING: This page is about a different variant/trim than selected.

The individual tests in Diagnostic Mode 06 display the results of emission related components and systems which are not continuously monitored.

The min max values for each individual test in Mode 06 represent the min max operating values for a properly operating system. This data is provided to the individual aftermarket scan tool companies for development of their scan tool. Depending on the scan tool being used, the min max values shown may vary, or be rounded up or down to the nearest decimal point depending on the aftermarket scan tool companies development process. e.g.:

	Minimum Value
GST Manual documentation	0.3499
Aftermarket Scan Tool display	0.35

Depending on the scan tool and protocol used, the information displayed in Diagnostic Mode 06 may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), On-Board Diagnostic Monitor Identifier (OBDMID), or contain no name at all and may be referenced by only a number.

NOTE:

Depending on the scan tool and protocol used, the information displayed in diagnostic mode 06 may be referred to by different names such as Test-ID (TID), Hex-ID, Component-ID (CID), or On-Board Diagnostic Monitor Identifier (OBDMID).

Test requirements

Exhaust system must be properly sealed between catalytic converter and cylinder head.
No DTCs in the DTC memory.
Coolant temperature at least 80°C.

Work procedure

Connect the scan tool.
Start the engine and let run at idle speed.
Select "Mode 6: Check test the results of components that are not continuously monitored".

Select the desired "Test-ID".

The current minimum and maximum values will be displayed on the scan tool screen.

Test-ID (Hex-ID)	Component or System
01 ($01): Test-ID 01 ($01): Catalytic Conversion (Bank 1)	Catalytic Conversion (Bank 1)
01 ($01): Test-ID 01 ($01): Catalytic Conversion (Bank 2)	Catalytic Conversion (Bank 2)
03 ($03): Test-ID $03 (03): Secondary Air Injection (AIR) System (Bank 1)	Secondary Air Injection (AIR) System (Bank 1)
03 ($03): Test-ID $03 (03): Secondary Air Injection (AIR) System (Bank 2)	Secondary Air Injection (AIR) System (Bank 2)
05 ($05): Test-ID $05 (05): Tank Ventilation System, Tank Vent Valve Function Check	Tank Ventilation System, Tank Vent Valve Function Check
05 ($05): Test-ID $05 (05): Tank Ventilation System, Tank Leak Test	Tank Ventilation System, Tank Leak Test
09 ($09): Test-ID 09 ($09): Coolant Thermostat	Coolant Thermostat