Test-ID $05 (05): Tank Ventilation System, Tank Leak Test
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 05 ($05)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 13 ($0D) | P0442 | Large/small leak. | 1.90 | 2.30 | Refer to P0442 under Test-ID $05 (05): Tank Ventilation System, Tank Leak Test . |
| 13 ($0D) | P0445 | Large/small leak. | 1.90 | 2.30 | Refer to P0455 under Test-ID $05 (05): Tank Ventilation System, Tank Leak Test . |
| 14 ($0E) | P2403 | Reed contact not closed. | 0.5 Seconds | Refer to P2403 under Test-ID $05 (05): Tank Ventilation System, Tank Leak Test . | |
| 15 ($0F) | P2404 | Reed contact does not open. | 25 | Refer to P2404 under Test-ID $05 (05): Tank Ventilation System, Tank Leak Test . | |
| 16 ($10) | System not OK during initial flush. | 0 | |||
| 17 ($11) | P0456 | Pinhole leak. | 4.20 | Refer to P0456 under Test-ID $05 (05): Tank Ventilation System, Tank Leak Test . | |
| 20 ($14) | Activated charcoal filter shut off valve. | 115 |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
End of diagnosis