Test-ID $05 (05): Tank Ventilation System, Tank Vent Valve Function Check
WARNING: This page is about a different variant/trim than selected.
- Connect the scan tool.
- Start the engine and let run at idle speed.
- Select "Mode 6: Check test the results of components that are not continuously monitored".
Select "Test-ID 05 ($05)".
- Select the desired "Test-ID".
- Check specified values at idle.
| Test-ID (TID) (Hex-ID) | DTC | Component or System | Min. | Max. | Additional Information |
|---|---|---|---|---|---|
| 01 ($01) | Tank ventilation valve check of DLDP during initial flush. | ||||
| 02 ($02) | Reduction of drop-out time when flushing. | ||||
| 03 ($03) | Passive test (can only test if OK). | 0.1484 | |||
| 04 ($04) | Active test: deviation of oxygen sensor regulator in lean direction (can only be checked if OK), also short test. | 0.07 | |||
| 05 ($05) | Active test: deviation of oxygen sensor regulator in rich direction (can only be checked if OK), also short test. | -0.07 | |||
| 06 ($06) | Active test: air balance at idle OK, also short test. | 35% | |||
| 07 ($07) | P0441 | Fuel Tank Leak Test. | 35% | Refer to P0441 under Test-ID $05 (05): Tank Ventilation System, Tank Vent Valve Function Check . |
- If any component or system fails to meet the specified values, refer to Diagnostic "Mode 03: Interrogating Fault Memory" to check for stored DTCs or the corresponding diagnostic repair procedure.
- Switch the ignition off.
End of diagnosis