Checking the connectors
WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.
Check connector 54/3 and the connector for the central electronic module (CEM) for contact resistance and oxidation according to Contact resistance and oxidation . Check for loose connections according to Loose connections (terminals) . Remedy if necessary.
Check for any damage.
HINT: If the fault cause is found, reinstall the components, connectors etc.
HINT: If the fault cause is not found, do not reinstall the central electronic module (CEM) before continuing with fault-tracing.
Other information:
- To access the central electronic module (CEM) connector, see Central electronic module (CEM), replacing
- For the intermediate connector see appropriate wiring diagram.
- To connect the breakout box to the control module, see Connecting the breakout box
- For further information about signals and other values, see Signal specification
Was a fault detected?
- YES
OKAY: Troubleshooting has been completed.
- NO
Refer to Checking the cable