Checking the cable

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2009 Volvo S60, 2008 Volvo S60, 2007 Volvo S60, 2006 Volvo S60, and 2005 Volvo S60. However, it is still accessible from the selected car via links, so may be relevant.

Check the cable between central electronic module connector terminal #20A and the ignition switch connector terminal #50. Check for an open-circuit according to Open-circuit, intermittent faults . Check for a short-circuit to ground according to Short-circuit to ground, intermittent faults .

Other information

The voltage must be the same as battery voltage if the key is in position III
To access or replace the central electronic module (CEM) connector, see Central electronic module (CEM), replacing
For the intermediate connectors see appropriate wiring diagram.
To connect the breakout box, see Connecting the breakout box
For further information about signals and other values, see Signal specification

Fig 1: Identifying Breakout Box

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 2: Identifying Ohmmeter

Courtesy of VOLVO CARS OF NORTH AMERICA.

Fig 3: Identifying Central Electronic Module (CEM) Connector Terminals

Courtesy of VOLVO CARS OF NORTH AMERICA.