Inspection Procedure

NOTE:

The power window control system uses a multiplex communication system (LIN communication system). Inspect the communication function by following How to Proceed with Troubleshooting (See HOW TO PROCEED WITH TROUBLESHOOTING ). Troubleshoot the power window control system after confirming that the communication system is functioning properly.
When the power window regulator motor assembly is reinstalled or replaced, the power window control system must be initialized.
After a door glass or a door glass run has been replaced, the jam protection function may operate unexpectedly when the auto up function is used. In such cases, the auto up function can be reinitialized by repeating the following operations at least 5 times:
1. Close the power window by fully pulling up the power window regulator master switch assembly or power window regulator switch assembly and holding it at the auto up position.
2. Open the power window by fully pushing down the power window regulator master switch assembly or power window regulator switch assembly.

PERFORM INITIALIZATION (APPLICABLE LOCATION)
1. Initialize the power window regulator motor assembly (applicable location) (See INITIALIZATION ).
CHECK POWER WINDOW CONTROL SYSTEM (AUTO UP/DOWN FUNCTION)
1. Check if the power window auto up/down function operates normally (See OPERATION CHECK ).
  OK: Auto up/down function is normal .
  
  NG: GO TO OTHER PROBLEM (Proceed to PROBLEM SYMPTOMS TABLE )
  
  OK: Go to Next Step

CHECK JAM PROTECTION FUNCTION OPERATING RANGE

Check if the jam protection function operates normally for the applicable power window.

HINT:

The jam protection function will not operate within 4 mm (0.157 in.) of the fully closed position.

OK: Jam protection function operates normally .

Result

RESULT CHART

Result	Proceed to
OK	A
NG (Driver side power window)	B
NG (Front passenger side power window)	C
NG (Rear LH side power window)	D
NG (Rear RH side power window)	E

B: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Side) (See REMOVAL )

C: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Front Passenger Side) (See REMOVAL )

D: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Side) (See REMOVAL )

E: REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear RH Side) (See REMOVAL )

A: END (PROBLEM DUE TO INITIALIZATION FAILURE)