LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Sienna LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 9 (Door Lock) >> Unlock Warning Switch >> Installation

Unlock Warning Switch: Installation

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY 
    1. Make sure that the ignition switch lock cylinder assembly is in the ACC position.
    2. Install the ignition switch lock cylinder assembly to the steering lock sub-assembly.
    3. Make sure that the ignition switch lock cylinder assembly is securely installed.
  2. INSTALL IGNITION SWITCH LOCK CYLINDER ASSEMBLY  (See REASSEMBLY )
  3. INSTALL SOLENOID WIRE (for Automatic Transaxle)  (See REASSEMBLY )
  4. INSTALL KEY INTERLOCK SOLENOID  (See REASSEMBLY )
    Fig 1: Identifying Unlock Warning Switch Claws
    G05389793Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Manual Transaxle)  (See REASSEMBLY )
  6. INSTALL IGNITION OR STARTER SWITCH ASSEMBLY (for Automatic Transaxle)  (See REASSEMBLY )
  7. INSTALL STEERING LOCK OPERATION  (See INSPECTION )
  8. INSTALL STEERING COLUMN UPPER WITH SWITCH BRACKET ASSEMBLY  (See REASSEMBLY )
  9. INSTALL NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY  (See INSTALLATION )
  10. INSTALL STEERING POST ASSEMBLY (for 2ZR-FE)  (See INSTALLATION )
  11. INSTALL STEERING POST ASSEMBLY (for 2AZ-FE)  (See INSTALLATION )
  12. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD 
  13. CONNECT NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY  (See INSTALLATION )
  14. INSTALL STOP LIGHT SWITCH ASSEMBLY  (See INSPECTION )
  15. INSTALL NO. 3 AIR DUCT SUB-ASSEMBLY  (See INSTALLATION )
  16. INSTALL INSTRUMENT PANEL SUB REINFORCEMENT  (See INSTALLATION )
  17. INSTALL COLUMN HOLE COVER SILENCER SHEET  (See INSTALLATION )
  18. INSTALL TRANSPONDER KEY AMPLIFIER  (See INSTALLATION )
  19. INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY 

    HINT:

    Refer to the instructions for Installation of the upper instrument panel (See INSTALLATION ).

  20. INSTALL TURN SIGNAL SWITCH ASSEMBLY WITH SPIRAL CABLE SUB-ASSEMBLY  (See INSTALLATION )
  21. INSTALL UPPER STEERING COLUMN COVER  (See INSTALLATION )
  22. INSTALL LOWER STEERING COLUMN COVER  (See INSTALLATION )
  23. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See INSTALLATION )
  24. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD 
  25. ADJUST SPIRAL CABLE  (See INSTALLATION )
  26. INSTALL STEERING WHEEL ASSEMBLY  (See INSTALLATION )
  27. INSTALL STEERING PAD  (See INSTALLATION )
  28. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  29. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  30. INSPECT STEERING WHEEL CENTER POINT 
  31. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  32. INSPECT STEERING PAD  (See INSTALLATION )
  33. INSPECT SRS WARNING LIGHT 

    (See DIAGNOSIS SYSTEM )

scientia non olet · About LEMON Manuals