LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2009 >> Sienna LE, AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 2 (Steering Column) >> Steering Wheel >> Installation

Steering Wheel: Installation

WARNING: This page is about a different car, the 2009 Toyota Corolla. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL STEERING WHEEL PAD ATTACHING SCREW 
    1. Install the 2 steering wheel pad attaching screws to the lower steering wheel boss cover.
    Fig 1: Identifying Steering Pad Attaching Screws
    G06010415Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL LOWER STEERING WHEEL BOSS COVER 
    1. Engage the 2 claws to install the lower steering wheel boss cover to the steering wheel sub-assembly.
      Fig 2: Identifying Lower Steering Wheel Boss Cover Claws
      G06010414Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the 2 screws.
  3. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)  (See INSTALLATION )
  4. INSTALL STEERING PAD SWITCH LH (w/ Steering Pad Switch)  (See INSTALLATION )
    Fig 3: Identifying Lower Steering Wheel Boss Cover Screws
    G06010413Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  5. INSTALL NO. 1 STEERING WHEEL ORNAMENT (w/ Steering Pad Switch) 
    1. Engage the 2 pins to install the No. 1 steering wheel ornament to the steering wheel sub-assembly.
      Fig 4: Identifying No. 1 Steering Wheel Ornament Pins
      G06010412Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Install the screw.
  6. INSTALL STEERING PAD SWITCH ASSEMBLY (w/ Microphone)  (See INSTALLATION )
  7. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD 
  8. ADJUST SPIRAL CABLE  (See INSTALLATION )
    Fig 5: Identifying No. 1 Steering Wheel Ornament Screw (W/ Steering Pad Switch)
    G06010411Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  9. INSTALL STEERING WHEEL ASSEMBLY 
    1. Align the matchmarks on the steering wheel assembly and steering main shaft.
    2. Install the steering wheel assembly set nut.

      Torque: 50 N*m (510 kgf*cm, 37 ft.*lbf) 

    3. Connect the connectors to the spiral cable sub-assembly.
    Fig 6: Identifying Matchmarks On Steering Wheel Assembly And Steering Main Shaft
    G06010421Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  10. INSTALL STEERING PAD  (See INSTALLATION )
  11. INSTALL LOWER NO. 3 STEERING WHEEL COVER  (See INSTALLATION )
  12. INSTALL LOWER NO. 2 STEERING WHEEL COVER  (See INSTALLATION )
  13. INSPECT STEERING WHEEL CENTER POINT 
  14. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL 
  15. INSPECT STEERING PAD  (See INSTALLATION )
  16. INSPECT SRS WARNING LIGHT 

    HINT:

    See DIAGNOSIS SYSTEM .

scientia non olet · About LEMON Manuals