Inspection Procedure

1. Check if the CAN communication system DTC is output (See DIAGNOSIS SYSTEM ).

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   CAN communication system DTC is not output	A
   CAN communication system DTC is output	B

B: INSPECT CAN COMMUNICATION SYSTEM 

A: Go to Next Step 

1. Check if the multiplex communication system DTC is output (See DTC CHECK / CLEAR ).

   Result 

   RESULT CHART
   
   

   Result	Proceed to
   Multiplex communication system DTC is not output	A
   Multiplex communication system DTC is output	B

B: INSPECT MULTIPLEX COMMUNICATION SYSTEM 

A: Go to Next Step 

1. Connect Techstream to the DLC3.
2. Start the engine.
3. Select the Active Test mode on Techstream (See DATA LIST / ACTIVE TEST  ).

   ABS / VSC / TRAC: 

   ACTIVE TEST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Lamp	SLIP indicator light	Indicator light ON / OFF	Observe combination meter

4. Check that "ON" and "OFF" of the SLIP indicator light are indicated on the combination meter when using Techstream.

   OK: The SLIP indicator light turns on or off in accordance with Techstream. 

   HINT:

   If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE , refer back to the table and proceed to the next step before replacing the part.

NG: Go to step 4 

OK: REPLACE BRAKE ACTUATOR ASSEMBLY 

1. Turn the ignition switch off.
2. Perform Active Test of the combination meter (meter CPU) using Techstream (See DATA LIST / ACTIVE TEST ).

   OK: The SLIP indicator light turns on or off in accordance with Techstream. 

   HINT:

   If troubleshooting has been carried out according to the PROBLEM SYMPTOMS TABLE , refer back to the table and proceed to the next step.

NG: REPLACE COMBINATION METER ASSEMBLY 

OK: REPLACE BRAKE ACTUATOR ASSEMBLY