LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Land Cruiser >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission >> Transmission Wire >> Removal

Transmission Wire: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
  2. REMOVE NO. 2 ENGINE UNDER COVER  (See REMOVAL  )
  3. REMOVE OIL PAN PROTECTOR ASSEMBLY  (See REMOVAL  )
  4. DRAIN AUTOMATIC TRANSMISSION FLUID 
    1. Remove the drain plug and gasket, and drain the ATF.
    2. Install a new gasket and the drain plug.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

  5. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY 
    1. Remove the 12 bolts, oil pan and gasket from the transmission.
      NOTE: Some fluid will remain in the oil pan. Remove all the bolts, and carefully remove the oil pan assembly.
      Fig 1: Locating Oil Pan Assembly Bolts
      G05629084Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Examine the particles in the pan.
      1. Remove the 4 magnets and use them to collect steel particles. Carefully inspect the foreign matter and particles in the pan and on the magnets to anticipate the type of wear you will find in the transmission.

        Steel (magnetic): bearing, gear and clutch plate wear

        Brass (non-magnetic): bush wear

        Fig 2: Identifying Particles In Pan
        G05629085Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  6. REMOVE VALVE BODY OIL STRAINER ASSEMBLY 
    1. Remove the 4 bolts and oil strainer.
      NOTE: Be careful as some fluid may leak out of the oil strainer.
    2. Remove the O-ring from the oil strainer.
      Fig 3: Locating Valve Body Oil Strainer Assembly Bolts
      G05629086Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  7. DISCONNECT TRANSMISSION WIRE 
    1. Remove the 2 bolts and 2 temperature sensor clamps.
    2. Disconnect the 2 ATF temperature sensors.
    3. Disconnect the 9 connectors from the solenoid valves.
      Fig 4: Locating Solenoid Valves Connectors, Bolts And Temperature Sensor Clamps
      G05629087Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  8. REMOVE TRANSMISSION WIRE 
    1. Disconnect the 2 wire connectors.

      HINT:

      Detach the claw, press down the lever, and then disconnect the transmission wire connector.

      Fig 5: Disconnecting Transmission Wire Connector
      G05629088Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 bolts and pull out the 2 transmission wires.
      Fig 6: Locating Transmission Wires Bolts
      G05629089Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002