LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2008 >> Land Cruiser >> Repair and Diagnosis >> Electrical >> Gauges >> Meter >> Light Control Rheostat >> Removal

Light Control Rheostat: Removal

  1. DISABLE AUTO TILT AWAY FUNCTION 
    1. Disable the Autoaway/Return function by changing the customize parameter (See CUSTOMIZE PARAMETERS ).
      NOTE: Record the current customize parameter setting (whether the Autoaway/Return function is enabled or disabled) in order to restore the current setting after finishing the operation.

      HINT:

      Performing the above operation causes the Autoaway/Return function to be disabled when the engine switch is turned off.

    2. Turn the engine switch on (IG). Operate the tilt and telescopic switch to fully extend and lower the steering column.
    3. Turn the engine switch off.
  2. REMOVE INSTRUMENT SIDE PANEL LH 
  3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH  (See REMOVAL  )
  4. REMOVE NO. 2 INSTRUMENT PANEL FINISH PANEL CUSHION  (See REMOVAL  )
  5. REMOVE LOWER INSTRUMENT PANEL PAD SUBASSEMBLY LH  (See REMOVAL  )
  6. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH  (See REMOVAL  )
  7. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY  (See REMOVAL  )
  8. REMOVE LIGHT CONTROL RHEOSTAT 
    1. Detach the 2 claws and remove the rheostat.
      Fig 1: Identifying Rheostat Claws
      G05635275Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About LEMON Manuals