Transmission Control Cable Assembly: Installation

INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY
1. Pull in the control cable to the body.
2. Install the 3 bolts.
  Torque: 4.9 N*m (50 kgf*cm, 43 in.*lbf)
  
  Fig 1: Installing 3 Bolts
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Install the cable end, as shown in the illustration.
  HINT:
  
  Install it with the uneven surface facing up.
  
  Fig 2: Disconnecting Cable End From Rod Of Floor Shift Assembly
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Install the control cable and 2 nuts.
  Torque: 11.8 N*m (122 kgf*cm, 9 ft.*lbf)
  
  Fig 3: Installing Control Cable
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
5. Connect the control cable to the control cable clamp.
  
  Fig 4: Connecting Control Cable To Control Cable Clamp
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
6. Temporarily install the control cable to the control shaft lever with the nut.
  
  Fig 5: Connecting Control Cable To Control Shaft Lever With Nut
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
7. Install the control cable and clip to the bracket.
INSTALL INSTRUMENT PANEL SAFETY PAD SUB-ASSEMBLY W/ PASSENGER AIR BAG ASSEMBLY
HINT:

(See INSTALLATION )
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Fig 6: Locating Control Cable Clip
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
INSPECT SHIFT LEVER POSITION (See ADJUSTMENT )
ADJUST SHIFT LEVER POSITION (See ADJUSTMENT )
CLEAR DTC
INSPECT SRS WARNING LIGHT
HINT:

(See DIAGNOSIS SYSTEM )