How To Proceed With Troubleshooting

HINT:

• The wireless door lock control system troubleshooting procedures are based on the premise that the power door lock system is operating normally. Check the power door lock system first before troubleshooting the wireless door lock control system.
• Use these procedures to troubleshoot the wireless door lock control system.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 

   Standard voltage: 

   11 to 14 V 

   If the voltage is below 11V, recharge or replace the battery before proceeding.

3. INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the intelligent tester to check if the CAN Communication System is functioning normally.

      Result: 

      RESULT REFERENCE
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

   B: GO TO DIAGNOSTIC TROUBLE CODE TABLE 

   A: Go TO NEXT STEP 

4. PROBLEM SYMPTOMS TABLE 

   Result: 

   RESULT REFERENCE
   
   

   Result	Proceed to
   Fault is not listed in problem symptoms table	A
   Fault is listed in problem symptoms table	B

   B:  Go to step  6

5. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. See TERMINALS OF ECU 
   2. See DATA LIST/ACTIVE TEST 
   3. See ON-VEHICLE INSPECTION 
6. REPAIR OR REPLACE 
7. CONFIRMATION TEST 

   NEXT: END