Charging System: Generator: Inspection

1. Check the rotor for open circuit.

   Using an ohmmeter, check that there is continuity between the slip rings.

   Standard resistance: 1.5 to 1.9 & Ω at 20° C (68° F) 

   If there is no continuity, replace the rotor.

   Fig 1: Checking Continuity Between Slip Rings

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Check the rotor for ground.

   Using an ohmmeter, check that there is no continuity between the slip ring and rotor. If there is continuity, replace the rotor.

3. Check that the slip rings are not rough or scored. If rough or scored, replace the rotor.
   Fig 2: Checking Continuity Between Slip Ring And Rotor

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. Using vernier calipers, measure the slip ring diameter.

   Standard diameter: 14.2 to 14.4 mm (0.559 to 0.567 in.) 

   Minimum diameter: 14.0 mm (0.551 in.) 

   If the diameter is less than the minimum, replace the rotor.

   Fig 3: Measuring Slip Ring Diameter

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Using vernier caliper, measure the exposed brush length.

1. Standard exposed length: 10.5 mm (0.413 in.) 
2. Minimum exposed length: 4.5 mm (0.177 in.) 

If the exposed length is less than the minimum, replace the brushes and the brush holder assembly.

Check the bearing is not rough or worn.

If necessary, replace the bearing (See REPLACEMENT  ).

Fig 4: Measuring Exposed Brush Length

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002