LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P1824 : Learning Value Initialization Data Reading Error >> DTC Troubleshooting

DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.
DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "CVT System Check" performed?  Go to Step 2. Go to CVT SYSTEM CHECK .
2  ROM communication circuit check 
  1. Push engine switch to change ignition mode to "ON", and disconnect TCM and solenoid connectors.
  2. Check for proper terminal connection to TCM and solenoid connectors.
  3. If connections are OK, check that ROM signal circuits (A1 - A3) are as follows.
    • Wiring harness resistance of ROM signal circuit is less than 1 Ω.
    • Insulation resistance of ROM signal circuit is infinity between solenoid connector and vehicle body ground.
    • Insulation resistance of wire harness is infinity between ROM signal circuit terminal and each terminal at solenoid connector.
    • Circuit voltage of ROM signal circuit is 0 - 1 V with push engine switch to change ignition mode to "ON".

Are they in good condition? 		 Go to Step 3. Repair or replace defective wire harness.
3  DTC recheck 
  1. Perform TCM INITIALIZATION AND LEARNING CONTROL .
  2. Clear DTC. See DTC CLEARANCE .
  3. Confirm that ignition mode of keyless push start system is in "OFF".
  4. Perform DTC confirmation procedure and check DTC.

Is there any DTC(s) detected? 		 DTC P1824: Substitute a known-good ROM (valve body assembly) and recheck DTC. Other than DTC P1824: Go to troubleshooting for applicable DTC. End.
scientia non olet · About LEMON Manuals