LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0962: Pressure Control Solenoid "A" Control Circuit Low/DTC P0963: Pressure Control Solenoid "A" Control Circuit High >> DTC Troubleshooting

DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.
DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "CVT System Check" performed?  Go to Step 2. Go to CVT SYSTEM CHECK .
2  Line pressure control solenoid valve drive circuit check 
  1. Confirm that ignition mode of keyless push start system is "OFF".
  2. Disconnect "C142", "E19" and "E20" connectors.
  3. Check for proper terminal connection to "C142", "E19" and "E20" connectors.
  4. If connections are OK, check the following points.
    • Resistance of "A1" circuit: less than 1 Ω
    • Resistance of "A1" circuit between "C142" connector and ground: infinity
    • Resistance between "A1" circuit terminal and each terminal at "C142" connector: infinity
    • Voltage of "A1" circuit: 0 - 1 V (with ignition mode of keyless push start system in "ON")

Are they in good condition? 		 Go to Step 3. Repair or replace defective wire harness.
3  Line pressure control solenoid valve check 
  1. Check resistance of line pressure control solenoid valve, see SOLENOID VALVE ON-VEHICLE INSPECTION .

Is it in good condition? 		 Substitute a known-good TCM and recheck DTC, see TRANSMISSION CONTROL MODULE (TCM) REMOVAL AND INSTALLATION . Replace line pressure control solenoid valve (valve body assembly), see VALVE BODY ASSEMBLY REMOVAL AND INSTALLATION  .
scientia non olet · About LEMON Manuals