LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0871: Transmission Fluid Pressure Sensor / Switch "C" Circuit Range / Performance >> DTC Troubleshooting

DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.
DTC TROUBLESHOOTING CHART

Step Action YES NO
1  Was "CVT System Check" performed?  Go to Step 2. Go to CVT SYSTEM CHECK .
2  Primary pressure sensor and its circuit check 
  1. Check primary pressure sensor and its circuit according to Step 2 through 3 of DTC P0842 / P0843  .

Are they in good condition? 		 Go to Step 3. Repair or replace defective parts.
3  Secondary pressure sensor and its circuit check 
  1. Check secondary pressure sensor and its circuit according to Step 2 through 3 of DTC P0847 / P0848  .

Are they in good condition? 		 Go to Step 4. Repair or replace defective parts.
4  Stall test 
  1. Perform STALL TEST .

Is it in good condition? 		 Substitute a known-good TCM and recheck DTC, see TRANSMISSION CONTROL MODULE (TCM) REMOVAL AND INSTALLATION . Replace primary pressure sensor / secondary pressure sensor (valve body assembly). Refer to VALVE BODY ASSEMBLY REMOVAL AND INSTALLATION  .
scientia non olet · About LEMON Manuals