LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0842: Transmission Fluid Pressure Sensor / Switch "A" Circuit Low/DTC P0843: Transmission Fluid Pressure Sensor / Switch "A" Circuit High >> DTC Confirmation Procedure >> P0842/P0843

DTC Confirmation Procedure: P0842/P0843

WARNING: This page is about a different variant/trim than selected.
NOTE:
  • If other DTC than P0842 or P0843 is newly detected during this "DTC Confirmation Procedure", troubleshoot the newly detected DTC in first.
  • Confirm that the following conditions are met in this procedure.
    • Battery voltage > 10.5 V
    • CVT fluid temperature at engine start ≥ -20 °C (-4 °F)
  1. Push engine switch to change ignition mode to "ON", and leave ignition mode in "ON" for 10 sec.
scientia non olet · About LEMON Manuals