LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P0722: Output Speed Sensor Circuit No Signal >> DTC Detecting Condition and Trouble Area

DTC Detecting Condition and Trouble Area

WARNING: This page is about a different variant/trim than selected.
DTC DETECTING CONDITION CHART

DTC detecting condition Trouble area
DTC P0722: Output Speed Sensor Circuit No Signal 
This DTC is detected if any one of the following conditions is met.
  • The secondary pulley speed is lower than 150 rpm for 5 sec. in a row when the primary pulley speed is higher than 1000 rpm.
  • The secondary pulley speed is 0 rpm for specified times when the vehicle speed is higher than 10 km/h (6 mile/h).

(1 D/C detection logic)
  • Secondary pulley speed sensor and/or its circuit
  • TCM
scientia non olet · About LEMON Manuals