LEMON Manuals: Even more car manuals for everyone
Home >> Suzuki >> 2013 >> Kizashi Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 1 (Continuously Variable Transaxle (CVT)) >> Diagnostic Information and Procedures >> DTC P062F: Internal Control Module EEPROM Error >> DTC Troubleshooting

DTC Troubleshooting

WARNING: This page is about a different variant/trim than selected.
DTC TROUBLESHOOTING CHART

Step Action YES NO
1  DTC check 
  1. Clear DTC, see DTC CLEARANCE .
  2. Push engine switch to change ignition mode to "OFF" and leave ignition mode in "OFF" for 10 sec.
  3. Push engine switch to change ignition

Is DTC P062F still indicated? 		 Go to Step 2. Check for intermittent trouble, see INTERMITTENT CONNECTION AND POOR CONTACT INSPECTION .
2  TCM power supply and ground circuits check 
  1. Check TCM power supply and ground circuits, see TCM POWER SUPPLY AND GROUND CIRCUIT CHECK .

Are they in good condition? 		 Substitute a known-good TCM and recheck DTC, see TRANSMISSION CONTROL MODULE (TCM) REMOVAL AND INSTALLATION . Repair or replace defective wire harness.
scientia non olet · About LEMON Manuals