Brake Pedal: Installation

WARNING: This page is about a different car, the 2023 Subaru Ascent. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .

Install the pedal assembly brake.
CAUTION: Replace the clevis pin with a new part, and apply a thin coat of grease to the clevis pin.

Preparation items:

Grease: Shell Gadus S2 V220 or equivalent

Tightening torque:

18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the stop light switch assembly. Ref. to BRAKE>STOP LIGHT SWITCH>INSTALLATION .
Install the column assembly steering. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING COLUMN>INSTALLATION .
Install the universal joint. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>UNIVERSAL JOINT>INSTALLATION .
Install the duct foot driver. Ref. to AIR CONDITIONER>HEATER DUCT>INSTALLATION>FOOT .
Install the knee airbag module. Ref. to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .
Install the cover LWR driver. Ref. to EXTERIOR/INTERIOR TRIM>INSTRUMENT PANEL LOWER COVER>INSTALLATION .
Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
Check that the brake light operate properly.
Check the brake pedal after installation. Ref. to BRAKE>BRAKE PEDAL>INSPECTION .