LEMON Manuals: Even more car manuals for everyone
Home >> Subaru >> 2021 >> Outback Base >> Repair and Diagnosis >> Brakes >> Mechanical - Hydraulic >> Brake System >> Brake Pedal >> Installation

Brake Pedal: Installation

CAUTION: Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .
  1. Install the pedal assembly brake.
    CAUTION: Replace the clevis pin with a new part, and apply a thin coat of grease to the clevis pin.

    Preparation items: 

    Grease: Shell Gadus S2 V220 or equivalent

    Tightening torque: 

    18 N.m (1.8 kgf-m, 13.3 ft-lb)

  2. Install the duct sub assembly foot driver. Ref. to CONSOLE DUCT .
  3. Install the column assembly steering. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING COLUMN>INSTALLATION .
  4. Install the universal joint. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>UNIVERSAL JOINT>INSTALLATION .
  5. Install the stop light switch assembly. Ref. to BRAKE>STOP LIGHT SWITCH>INSTALLATION .
  6. Install the knee airbag module. Ref. to AIRBAG SYSTEM>KNEE AIRBAG MODULE>INSTALLATION .
  7. Install the cover LWR driver.
  8. Connect the ground terminal to battery sensor. Ref. to REPAIR CONTENTS>NOTE>BATTERY .
  9. Check that the brake light operate properly.
  10. Check the brake pedal after installation. Ref. to BRAKE>BRAKE PEDAL>INSPECTION .
scientia non olet · About LEMON Manuals