Combination Switch (Light): Removal
CAUTION:
Before handling the airbag system components, refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Ref. to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION
.
- Set the tire to the straight-ahead position.
- Disconnect the ground terminal from the battery sensor, and wait for at least 60 seconds before starting work. Ref. to GROUND TERMINAL REMOVAL OR INSTALLATION .
- Remove the driver's airbag module. Ref. to AIRBAG SYSTEM>DRIVER'S AIRBAG MODULE>REMOVAL .
- Remove the steering wheel. Ref. to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING WHEEL>REMOVAL .
- Remove the column cover assembly.
- Release the clips and claws, and remove the cover steering UPR.
- Remove the screws.
- Release the claw, and remove the column cover LWR as shown in the figure.NOTE:
- Release the claws on RH side in the same procedure as on the LH side.
- For models with keyless access with push button start, remove the cap key cylinder.
- Release the claw, and remove the column cover UPR as shown in the figure.
- Remove the steering roll connector. Ref. to AIRBAG SYSTEM>ROLL CONNECTOR>REMOVAL .
- Remove the switch assembly combination wiper. Ref. to WIPER AND WASHER SYSTEMS>COMBINATION SWITCH (WIPER)>REMOVAL .
- Remove the switch assembly combination turn dimmer.