Sunroof Motor: Installation
CAUTION:
- For installation of the cover assembly stereo camera, refer to "INSTALLATION", "Stereo Camera Cover" in the "EyeSight" information and observe the precautions for installation. Refer to EyeSight>Stereo Camera>INSTALLATION .
- When installing the sunroof motor, be careful not to move the cable assembly.
- Install the motor assembly.
Tightening torque:
5.4 N.m (0.6 kgf-m, 4 ft-lb)
- Install the cover assembly stereo camera. Refer to EyeSight>Stereo Camera>INSTALLATION .
- Connect the ground terminal to battery sensor. Refer to REPAIR CONTENTS>NOTE>BATTERY .
- Perform the initialize operation. Refer to SUNROOF/T-TOP/CONVERTIBLE TOP (SUNROOF)>Sunroof Control System>OPERATION>INITIALIZE OPERATION .
- Check the operation of sunroof by following the table below.
Operation Switch position (1) Glass lid closes completely. Close (2) Glass lid tilt up to the top position. Tilt up (3) Glass lid closes completely. Tilt down (4) Glass lid opens 368 mm (14.49 in) away from completely closed position. Open (5) Glass lid opens completely. Open (6) Glass lid closes completely. Close