CVT Model

CAUTION: Before handling the airbag system components, always refer to "CAUTION" of "General Description" in "AIRBAG SYSTEM". Refer to AIRBAG SYSTEM>GENERAL DESCRIPTION>CAUTION .

Install the brake pedal assembly.
CAUTION:
- Apply grease to the snap pin to prevent the operating rod from wear.
- Replace the clevis pin with new parts, and apply thin coat of NIGTIGHT LYW No. 2 grease to the clevis pin.
Tightening torque:

Brake pedal: 18 N.m (1.8 kgf-m, 13.3 ft-lb)
Install the column assembly - steering. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>STEERING COLUMN>INSTALLATION .
Install the universal joint assembly - steering. Refer to POWER ASSISTED SYSTEM (POWER STEERING)>UNIVERSAL JOINT>INSTALLATION .
CAUTION:
- Always install the universal joint assembly - steering after installing the steering column to avoid damage to the universal joint assembly - steering.
- Be sure to follow the tightening order and tightening torque of the universal joint assembly steering to avoid the steering effort from becoming heavy. After confirming that the steering column position is in the neutral position, tighten the universal joint assembly steering.
- Always place the tilt lever to the lock position after the steering column is adjusted.
Install the knee airbag module.
Tightening torque:

7.5 N.m (0.8 kgf-m, 5.5 ft-lb)
Install the cover assembly - instrument panel LWR driver.
Connect the battery ground terminal. Refer to NOTE>NOTE>BATTERY .
Check that the brake light operate properly.
Check the brake pedal after installation. Refer to BRAKE>BRAKE PEDAL>INSPECTION .