Rear Seat: Assembly
CAUTION:
- Do not reuse hog rings.
- Secure the hog ring using hog ring pliers.
- Install the hog rings to the specified points securely and make sure that there is no wrinkle or twisting on the cover COMPL - rear backrest.
- Assemble the cover COMPL - rear backrest and the cover - rear cushion in the same manner as for the front seat. <Ref. to ASSEMBLY , Front Seat.>
- Install the hog rings (A) on the back side of the rear seat cushion assembly.
- Install the hog rings and wire clip, then install the cover COMPL - rear backrest LH.NOTE:
- Do not contaminate or damage the cover COMPL - rear backrest and the cover - rear cushion.
- While installing the hog rings, prevent the cover COMPL - rear backrest and the cover - rear cushion from getting wrinkled.
- Install the plastic fastener and hog ring, and then install the headrest cover.
- Install the pad assembly - main LH.
- Install the bushing - headrest and the bushing - lock assembly.
- Install the lock assembly - rear backrest rear LH.
Tightening torque:
22.5 N.m (2.3 kgf-m, 16.6 ft-lb)
- Install the plastic hooks on the back side of the backrest assembly LH.
- Install the clips on the backside of the cover COMPL - rear backrest LH.
- Install the knob - backrest. (Screw-in type)
- Referring to the above steps, install the pad assembly - main RH.
Tightening torque:
Refer to "COMPONENT" of "General Description". <Ref. to REAR SEAT , COMPONENT, General Description.>
- Install the headrest assembly - rear backrest.
- Before installation, check the following items.
- No tear and fray on the cover COMPL - rear backrest and the cover - rear cushion.
- No fray or deformation on each wire cable.
- Install the rear seat. <Ref. to INSTALLATION , Rear Seat.>